A
L
B
E
D
O
T
e
l
e
c
o
m
-
J
o
a
n
d
’
À
u
s
t
r
i
a
,
1
1
2
-
B
a
r
c
e
l
o
n
a
-
0
8
0
1
8
-
w
w
w
.
a
l
b
e
d
o
t
e
l
e
c
o
m
.
c
o
m
User Guide
188
To configure the RFC 6349 thresholds, follow these steps:
1. From the Home panel, go to TEST,
The test configuration panel is displayed.
2. Go to Performance test and make sure that the RFC 6349.is configured.
3. Go to RFC 6349 objectives
4. Configure the value of Minimum throughput, Minimum efficiency and Maximum
buffer delay.
Note: You can set any of these values to 0 if you want them not to generate a
Pass / Fail result and not to participate in the global RFC 6349 Pass / Fail result.
7.3.3. Retrieving the Results
Once the RFC 6349 test has been configured and the performance objectives are
adjusted, the test is ready to run. To start execution press run at any moment. You can
wait to the end of the test do check the results but you can also get a partial view of
these results during test execution. These are the steps required to and display results:
1. From the Home panel, go to RESULTS,
The test port results panel is displayed.
Table 7.11: RFC 6349 Performance Objectives
Setting Description
Minimum throughput Defines the minimum TCP throughput that generates a Pass
result in the RFC 6349 throughput test. This threshold
matches with both the Upstream and the Downstream TCP
throughput and generates a Fail if any of these is smaller
than the threshold.
If the value of this field is set to zero then it will not be taken
into account to generate the Pass / Fail result.
Minimum efficiency Configures the minimum TCP efficiency that generates a
Pass result in the RFC 6349 throughput test. This threshold
matches with both the Upstream and the Downstream
Efficiency result displayed in the Throughput test panel.
If the value of this field is set to zero then it will not be taken
into account to generate the Pass / Fail result.
Maximum buffer
delay
Configures the maximum TCP buffer delay that generates a
Pass result in the RFC 6349 throughput test. This threshold
matches with both the Upstream and the Downstream Buffer
delay result displayed in the Throughput test panel.
If the value of this field is set to zero then it will not be taken
into account to generate the Pass / Fail result.
To Next Page