Automatic Performance Tests
177
The procedure to follow to display the performance test results is similar than for the
CIR results but in this case it is necessary to go the eSAM Performance test result
panel rather than to the eSAM Configuration test panel.
7.2.7. Generation of eSAM Result Reports
Report generation for eSAM works in a similar way that for RFC 2544. There’s no need
to make any special configuration in order to get the eSAM test report. It is only
necessary to enable report generation (See section 11.1).
Report organization is similar than in other tests, The report contains a header,
containing details about which equipment has been used to run the test, when the
tester has been executed, and other information, a global Pass / Fail indication,
followed by test-specific Pass / Fail indications, a summary of the test setup and finally
detailed descriptions of the eSAM configuration and performance tests.
eSAM test report
Report name 2013-04-11-173048
Custom
Department
Company
Location
Operator
Start Time Thu Apr 11 17:30:48 2013
Elapsed Time 00:03:08
Test Unit Ether.Giga Gigabit Ethernet Tester
Serial number MEM0009P
Software version 1.13.35
Global results (Port A)
Service Status
Global status --- PASS
eSAM Configuration test 1 PASS
eSAM Configuration test 2 PASS
eSAM Configuration test 3 PASS
eSAM Configuration test 4 PASS
eSAM Performance test --- PASS
Test Unit Configuration
Mode IP endpoint
Test method Two-way (A > A)
Port A Port B
Port mode TX/RX Loopback
Connector Electrical Optical
eSAM test configuration
Color mode On
Color method DSCP
To Next Page