Test Management
273
1. From the Home panel, go to File (),
The tester file manager base menu is displayed.
2. Select Configuration files or Report files.
3. Select Internal memory, to list the files currently stored in the unit.
4. Select the files you want to export.
5. Press the Export contextual button.
A popup menu to select the external device where the files will be exported is
opened.
Note: If there is no external device connected to the unit, a No devices present
popup panel is displayed.
6. Select an external device, confirm, and wait for the files to be copied.
Remove the USB storage device or micro SD card from the unit.
11.2.5.Importing Configurations
If you have a configuration file from a compatible tester you can import and load this file
in your unit to reproduce similar measurements. This is the procedure you have to
follow:
1. From the Home panel, go to File (),
The tester file manager base menu is displayed.
2. Select Configuration files to go to the configuration file settings.
3. Select External devices to list the files currently stored in the external device.
A popup menu to select the source external device is opened.
Note: If there is no external device connected to the unit, a No devices present
popup panel is displayed.
4. Select the configuration files you want to import.
5. Press the Import contextual button, confirm, and wait for the files to be copied
from the internal memory.
6. Remove the USB storage device or micro SD card from the unit.
11.2.6.Verifying the Current Disk Usage
Configurations, Reports and Event logs share the same storage space in the disk.
Users are allowed to check which is the disk occupation status and depending on the
result they can decide to delete files of a certain type. The procedure to do that is as
follows:
1. From the Home panel, go to File (),
The tester file manager base menu is displayed.
2. Select Disk usage.
The disk usage is displayed graphically and the storage space used for each file
type is shown in KB or MB.
To Next Page
Loading...