Albedo xGenius - Configuring What to Do When the Disk Is Full; Using the Embedded Web Server

A
L
B
E
D
O
T
e
l
e
c
o
m
-
J
o
a
n
d
’
À
u
s
t
r
i
a
,
1
1
2
-
B
a
r
c
e
l
o
n
a
-
0
8
0
1
8
-
w
w
w
.
a
l
b
e
d
o
t
e
l
e
c
o
m
.
c
o
m
User Guide
274
3. Optionally, select Configuration files, Report files or Event logger files and delete
all files of these type with the appropriate contextual key.
11.2.7.Configuring What to Do When the Disk is Full
Users decide what to do when the disk storage capacity is exhausted. The available
options are:
• Block measurements: No new measurements can be run when the internal mem-
ory is full.
• Stop file generation: New measurements are run even if the internal memory is full
but no reports are generated for them.
• Delete oldest files: When the maximum available capacity is reached, new files
replace the older ones. Use this action with care. No warning is displayed when
old reports are deleted.
To configure this action, the correct procedure is:
1. From the Home panel, go to File (),
The tester file manager base menu is displayed.
2. Configure Action when disk full to Block measurements, Stop file generation,
Delete oldest files.
11.2.8.Using the Embedded Web Server
As an alternative of using a USB external storage device or a micro SD card for file
management, the tester has a web interface that can be used for the same purpose.
The web interface can be used for downloading configurations, reports and event log
files from a remote computer without using any accessory other than an standard
network connection. Currently, the web interface does not support file uploading but for
this purpose, the USB and micro SD interfaces are still available.
To use the web interface you need to connect the platform network connector to the
management network and configure the management Ethernet interface (See section
11.4.1). Once you have done this, follow this procedure:
1. Open a browser in a computer with network connection.
2. Type the IP address you have assigned to the tester in the browser destination
URL.
The web interface home panel is displayed in the Internet browser.
3. Choose the files you want to display (Configuration flies, Report files, Event logger
files or any other if available) and the location of these files (Internal memory,
USB, SD-CARD) and press to the correct hyper link.
A list with the available files for the selected category is displayed in the web
browser.