Test Management
271
11.2.File Management
xGenius stores configurations, event logs and reports in files. These files can be
deleted, renamed or exported to an external USB memory or micro SD card.
Configurations can be shared between different test units by means compatible
storage devices. Report files can be included to documents, sent by e-mail or printed.
Event logger files can be processed by external software packages to generate
sophisticated plots or other kinds of data representations.
11.2.1.Saving Configurations
To store the current configuration follow these steps:
1. From the Home panel, go to File (),
The tester file manager base menu is displayed.
2. Select Configuration files to go to the configuration file settings.
3. Select the location to save the configuration: Internal memory, or External devices.
Note: If you select External devices, you will be asked to choose the specific stor-
age device (USB device or micro SD card).
Note: If there is no external device connected to the unit, a No devices present
popup panel is displayed.
4. Press the Save contextual button.
5. Enter a file name for the configuration file that is going to be saved and confirm
with the Done contextual button.
Report header This menu item enables you to configure report data that will
be stored with the test result. These data identify the report,
customer, and also includes some other relevant information.
• Customer: Field that can be used to set the company
where the test report applies.
• Department: This field can be used to identify the depart-
ment where the user that has carried out the tester.
belongs.
• Company: This is the field that identifies the company that
carries out the test.
• Location: This describes where the test results from the
network were recorded.
• Operator: This field may contain the name of the operator
that owns the network infrastructure where the test was
run.
Table 11.1: Report Files Panel
Setting Description
To Next Page