A
L
B
E
D
O
T
e
l
e
c
o
m
-
J
o
a
n
d
’
À
u
s
t
r
i
a
,
1
1
2
-
B
a
r
c
e
l
o
n
a
-
0
8
0
1
8
-
w
w
w
.
a
l
b
e
d
o
t
e
l
e
c
o
m
.
c
o
m
User Guide
276
4. If you want the automatic test to stop at a specific time after it has started set Stop
mode to Auto and enter test duration with the help of the Duration and User dura-
tion controls.
Note: Manual stop has precedence over autostop. That means that if a tester is
stopped by pressing Run but there is an automatic test programmed the manual
test will stop anyway.
Table 11.2: Autostart / stop Panel
Setting Description
Start mode Configures the start test mode. There are two different
choices here:
• Manual: The test starts when there is not an ongoing test
and Run is pressed.
• Auto: The test starts at a configured date and time without
the need of pressing any key.
Start time Enter the start date and time for the next automatic measure-
ment with the following format: dd/MM/yyyy hh:mm:ss.
To configure Start time, you have to set Start mode to Auto
before.
Stop mode Configures the stop test mode. There are two possibilities:
• Manual: The test finishes when there is an ongoing test
and Run is pressed.
• Auto: The test finishes when a configurable test duration is
reached. This mode does not require user intervention
once the duration has been set and the measurement has
started.
Duration Sets the duration of the next measurement. The available
test durations are: 15 minutes, 1 hour, 1 day, 7 days, 30 days
or user configurable duration.
Setting up Duration requires previous configuration of Stop
Mode to Auto.
User duration Sets the duration of the next measurement when Stop mode
has been configured to Auto and Duration to User.
The duration has to be entered in a hh:mm:ss format.
Last started on Displays the date and time when the last measurement was
started.
Last stopped on Displays the date and time when the last measurement was
stopped. If there is an ongoing test, the value of this field is
empty.
To Next Page