A
L
B
E
D
O
T
e
l
e
c
o
m
-
J
o
a
n
d
’
À
u
s
t
r
i
a
,
1
1
2
-
B
a
r
c
e
l
o
n
a
-
0
8
0
1
8
-
w
w
w
.
a
l
b
e
d
o
t
e
l
e
c
o
m
.
c
o
m
User Guide
278
Time display Select the way the time is displayed in the graphical user
interface. One of the following has to be selected:
• Elapsed: Time from the beginning of the test is displayed
with the following format hh:mm:ss. If there is not an ongo-
ing test, then the duration of the last test is shown
• Absolute: The current date and time is displayed with the
following format: dd/MM/yyyy hh:mm:ss.
Screensaver Sets or unsets the screen saver. The screen saver reduces
power consumption and increases operation time under bat-
tery operation.
Screensaver delay Configures the delay to switch the screensaver on. The back-
light brightness is set to a low value once the time configured
here has finished. The display backlight is switched off after
twice the screensaver delay. The available configuration val-
ues for this item are: 10s, 30s, 1min, 2min, 5min, 10min,
20min.
Remote control This is a menu that contains the controls necessary to enable
and configure the VNC remote control. The items contained
in this menu are:
• Enable: Enables or disables the Ethernet / IP remote con-
trol. The remote control is an optional feature that enables
remote users to use the tester from a computer running
VNC.
• Remote control password: Configures a password for the
remote control. Any alphanumeric string should be
accepted. Use the same password in the remote VNC cli-
ent to access to the tester user interface.
Table 11.3: General Settings Panel
Setting Description
To Next Page