Service Management Tasks
Page 146 7210 SAS D, E, K OS Basic System Configuration Guide
Service Management Tasks
This section discusses the following service management tasks:
• System Administration Commands on page 146
→ Viewing the Current Configuration on page 146
→ Modifying and Saving a Configuration on page 148
→ Deleting BOF Parameters on page 149
→ Saving a Configuration to a Different Filename on page 151
System Administration Commands
Use the following administrative commands to perform management tasks.
CLI Syntax: A:ALA-1# admin
auto-init stop
check-golden-bootstrap
debug-save [<file-url>]
disconnect [address <ip-address> | username <user-name> |
{console|telnet|ftp|ssh}]
display-config
[no]enable-tech
reboot [auto-init][now]
save [file-url] [detail] [index]
set-time <date> <time>
tech-support <file-url>
update-golden-bootstrap [file-url]
Viewing the Current Configuration
Use one of the following CLI commands to display the current configuration. The
detail
option
displays all default values. The
index
option displays only the persistent indices. The
info
command displays context-level information.
CLI Syntax: admin# display-config [detail|index]
info detail
The following displays an example of a configuration file:
*A:sim169# admin display-config
# TiMOS-B-0.0.I218 both/i386 ALCATEL SAS-E 7210 Copyright (c) 2000-2008 Alcatel-
Lucent.
# All rights reserved. All use subject to applicable license agreements.
To Next Page
Loading...
