Show Commands
Page 174 7210 SAS D, E, K OS Basic System Configuration Guide
.
Sample Output
*A:ALA# show bof cf1:
===============================================================================
BOF on cf1:
===============================================================================
autonegotiate
No autonegotiate — Autonegotiate not enabled.
autonegotiate — Autonegotiate is enabled.
console speed
The console port baud rate.
ping-address
The IPv4 IP address to be used for ping-test after auto-init.
dns domain
The domain name used when performing DNS address resolution.
uplinkA-address
Displays the Uplink-A IP address.
uplinkA-port
Displays the primary port to be used for auto-boot.
uplinkA-route
Displays the static route associated with Uplink-A.
uplinkA-vlan
Displays the VLAN ID to be used on Uplink-A.
uplinkB-address
Displays the Uplink-B IP address.
uplinkB-port
Displays the secondary port to be used for auto-boot.
uplinkB-route
Displays the static route associated with Uplink-B.
uplinkB-vlan
Displays the VLAN ID to be used on Uplink-B.
console-disabled
Displays the status of serial port console.
Table 16: Show BOF Output Fields (supported only on 7210 SAS-E)
Label Description
eth-mgmt-disabled
Displays if Ethernet management is disabled.
eth-mgmt-addressg
Displays the Ethernet management address.
eth-mgmt-route
Displays the Ethernet Management route.
eth-mgmt-autoneg
Displays if the auto-negotiate is enabled.
eth-mgmt-duplex
Displays the mode of the Ethernet management port.
eth-mgmt-speed
Displays the Ethernet management speed.
Table 15: Show BOF Output Fields (Continued)
Label Description
To Next Page
Loading...
