Alcatel-Lucent 7210 SAS-D User Manual

Navigating in the CLI
Page 26 7210 SAS D, E, K OS Basic System Configuration Guide
CLI Monitor Commands
Monitor commands display specified statistical information related to the monitor subject (such as
filter, port, QoS, router, service) at a configurable interval until a count is reached. The CLI
monitor commands are found in the root>monitor context of the CLI tree.
The monitor command output displays a snapshot of the current statistics. The output display
refreshes with subsequent statistical information at each configured interval and is displayed as a
delta to the previous display.
The
<Ctrl-c> keystroke interrupts a monitoring process. Monitor command configurations
cannot be saved. You must enter the command for each monitoring session. Note that if the
maximum limits are configured, you can monitor the statistical information for a maximum of 60
* 999 sec ~ 1000 minutes.
The CLI monitor command contexts are listed in Table 4.
Table 5: CLI Monitor Command Contexts
Command Description Page
filter
Enables IP, IPv6 and MAC filter monitoring at a configurable
interval until that count is reached.
68
lag
Enables Link Aggregation Group (LAG) monitoring to display
statistics for individual port members and the LAG.
73
port
Enables port traffic monitoring. The specified port(s) statistical
information displays at the configured interval until the
configured count is reached.
75
service
Monitors commands for a particular service. 77

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English