Root Commands
7210 SAS D, E, K OS Basic System Configuration Guide Page 75
ipv6
Syntax ipv6 entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>management-access-filter
Description Platforms Supported: 7210 SAS-D and 7210 SAS-E.
This command nonitors statistics for the MAF IPv6 filter entry.
Parameters entry entry-id — Specifies an existing IP MAF entry ID.
Values 1 — 9999
interval seconds — Configures the interval for each display in seconds.
Default 10
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
port
Syntax port port-id [port-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command enables port traffic monitoring. The specified port(s) statistical information displays
at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified port(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display. When the
keyword rate is specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters port port-id — Specify up to 5 port IDs.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60