Alcatel-Lucent 7210 SAS-D - Page 74

Monitor CLI Commands
Page 74 7210 SAS D, E, K OS Basic System Configuration Guide
-------------------------------------------------------------------------------
1/1/1 0 0 0 0 0 0
1/1/2 258 3 86 1 0 0
1/1/3 82 1 0 0 0 0
-------------------------------------------------------------------------------
Totals 340 4 86 1 0 0
===============================================================================
A:ALA-12#
management-access-filter
Syntax management-access-filter
Context monitor
Description This command enables the context to monitor management-access filters. These filters are configured
in the config>system>security>mgmt-access-filter context.
ip
Syntax ip entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>management-access-filter
Description Platforms Supported: 7210 SAS-D and 7210 SAS-E.
This command nonitors statistics for the MAF IP filter entry.
Parameters entry entry-id — Specifies an existing IP MAF entry ID.
Values 1 — 9999
interval seconds — Configures the interval for each display in seconds.
Default 10
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.