EasyManua.ls Logo

Alcatel-Lucent 7210 SAS-D - BOF Command Reference

Alcatel-Lucent 7210 SAS-D
462 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Boot Option Files
7210 SAS D, E, K OS Basic System Configuration Guide Page 153
BOF Command Reference
Command Hierarchies
Configuration Commands
NOTE:
Not all the commands are supported on all the 7210 platforms. Please read
the CLI description to know which platforms support these commands.
bof
— bof-password
— [no] console-disabled
— console-speed baud-rate
—no console-speed
— dns-domain dns-name
—no dns-domain
— [no] eth-mgmt-address ip-prefix/ip-prefix-length
— [no] eth-mgmt-autoneg
— [no] eth-mgmt-address
— [no] eth-mgmt-disabled
— eth-mgmt-duplex {full | half}
— [no] eth-mgmt-route ip-prefix/ip-prefix-length next-hop ip-address
— eth-mgmt-speed speed
— persist {on | off}
— ping-address ip-address
—no ping-address
— primary-config file-url
—no primary-config
— primary-dns ip-address
—no primary-dns
— primary-image file-url
—no primary-image
— save [cflash-id ]
— secondary-config file-url
—no secondary-config
— [no] secondary-dns ip-address
— secondary-image file-url
—no secondary-image
— tertiary-config file-url
—no tertiary-config
— tertiary-dns ip-address
—no tertiary-dns
— tertiary-image file-url
—no tertiary-image
— wait seconds
— uplinkA-address ip-address/mask
—no uplinkA-address
— uplinkA-port port-id
—no uplinkA-port
— [no] uplinkA-route ip-address/mask next-hop ip-address
— uplinkA-vlan 0..4094

Table of Contents