Boot Option Files
7210 SAS D, E, K OS Basic System Configuration Guide Page 167
uplinkA-vlan
Syntax uplinkA-vlan 0..4094
no uplinkA-vlan
Context bof
Description This command specifies a VLAN ID to be used on uplink-A.
The no form of the command is used to send untagged packets on uplink-A.
uplinkB-vlan
Syntax uplinkB-vlan 0..4094
no uplinkA-vlan
Context bof
Description This command specifies a VLAN ID to be used on uplink-B.
The no form of the command is used to send untagged packets on uplink-B.
eth-mgmt-address
Note: This command is not supported on 7210 SAS-D and 7210 SAS-K devices.
Syntax [no] eth-mgmt-address ip-prefix\ip-prefix-length
Context bof
Description Platforms Supported: 7210 SAS-E.
This command assigns an IP address to the management Ethernet port in the running configuration
and the Boot Option File (BOF). Deleting a BOF address entry is not allowed from a telnet session.
The no form of the command deletes the IP address assigned to the Ethernet port.
Default no eth-mgmt-address — There are no IP addresses assigned to the out-of-band Ethernet
management ports.
Parameters
ip-prefix\ip-prefix-length — The IP address in dotted decimal notation.
Values ipv4-prefix a.b.c.d (host bits must be 0)
ipv6-prefix - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
To Next Page
Loading...
