Alcatel-Lucent 7210 SAS-D User Manual

File Management Commands
Page 168 7210 SAS D, E, K OS Basic System Configuration
x - [0..FFFF]H
d - [0..255]D
Values ipv4-prefix-length 0 — 32
Values ipv6-prefix-length 0 — 128
eth-mgmt-autoneg
Note: This command is not supported on 7210 SAS-D and 7210 SAS-K devices.
Syntax [no] eth-mgmt-autoneg
Context bof
Description Platforms Supported: 7210 SAS-E.
This command enables speed and duplex Auto-negotiation on the management Ethernet port in the
running configuration and the Boot Option File (BOF).
The no form of the command disables the Auto-negotiate feature on this port.
Default eth-mgmt-autoneg — Auto-negotiation is enabled on the management Ethernet port.
eth-mgmt-disabled
Note: This command is not supported on 7210 SAS-D and 7210 SAS-K devices.
Syntax [no] eth-mgmt-disabled
Context bof
Description Platforms Supported: 7210 SAS-E.
This command allows the user to enable or disable the out-of-band management Ethernet port for use
during boot up.
The no form of the command enables the port.
Default eth-mgmt-disabled
eth-mgmt-duplex
Note: This command is not supported on 7210 SAS-D and 7210 SAS-K devices.
Syntax eth-mgmt-duplex {full | half}
Context bof
Description Platforms Supported: 7210 SAS-E.
This command configures the duplex mode of the management Ethernet port when Auto-negotiation
is disabled in the running configuration and the Boot Option File (BOF).

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English