EasyManuals Logo

Alcatel-Lucent 7210 SAS-D User Manual

Alcatel-Lucent 7210 SAS-D
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
Boot Option Files
7210 SAS D, E, K OS Basic System Configuration Guide Page 169
This configuration command allows for the configuration of the duplex mode of the Ethernet port. If
the port is configured to Auto-negotiate, this parameter will be ignored.
Default eth-mgmt-duplex full — Full duplex operation.
Parameters full — Sets the link to full duplex mode.
half — Sets the link to half duplex mode.
eth-mgmt-route
Note: This command is not supported on 7210 SAS-D and 7210 SAS-K devices.
Syntax [no] eth-mgmt-route ip-prefix/ip-prefix-length next-hop ip-address
Context bof
Description Platforms Supported: 7210 SAS-E.
This command creates a static route entry for the management Ethernet port in the running
configuration and the Boot Option File (BOF).
This command allows manual configuration of static routing table entries. These static routes are only
used by traffic generated by the Ethernet port. To reduce configuration, manual address aggregation
should be applied where possible.
A static default (0.0.0.0 or 0) route cannot be configured on the management Ethernet port. A
maximum of ten static routes can be configured on the management Ethernet port.
The no form of the command deletes the static route.
Default No default routes are configured.
Parameters ip-prefix\ip-prefix-length — The destination address of the static route in dotted decimal notation.
100 — The destination address of the static route in dotted decimal notation.
Values ip-prefix|ip-prefix-length: ipv4-prefix a.b.c.d (host bits must be zero) ipv4-prefix-le
0 — 32
ipv6-prefix - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D
Values Values mask — The subnet mask, expressed as an integer or in dotted decimal
notation. 0 — 32 (mask length), 128.0.0.0 — 255.255.255.255 (dotted decimal)
ipv6-prefix-length - 0 — 128
next-hop ip-address — The next hop IP address used to reach the destination.
Values ipv4-address - a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS-D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS-D and is the answer not in the manual?

Alcatel-Lucent 7210 SAS-D Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS-D
CategorySwitch
LanguageEnglish

Related product manuals