System Commands
Page 426 7210 SAS D, E, K OS Basic System Configuration Guide
===============================================================================
-------------------------------------------------------------------------------
Time Information
-------------------------------------------------------------------------------
Timescale : PTP
Current Time : 2012/12/13 11:05:43 (UTC)
Frequency Traceable : yes
Time Traceable : yes
Time Source : GPS
===============================================================================
===============================================================================
A:7210SAS>show>system#
sntp
Syntax sntp
Context show>system
Description This command displays SNTP protocol configuration and state.
Output Show SNTP Output — The following table describes SNTP output fields.
Sample Output
*A:pc-4.0# show system sntp
===============================================================================
SNTP Status
===============================================================================
Admin Status : up Oper Status : up Mode : broadcast
===============================================================================
===============================================================================
SNTP Servers
===============================================================================
Table 39: Show System SNTP Output Fields
Label Description
SNTP Server
The SNTP server address for SNTP unicast client mode.
Version
The SNTP version number, expressed as an integer.
Preference
Normal — When more than one time server is configured, one
server can be configured to have preference over another.
Preferred — Indicates that this server has preference over another.
Interval
The frequency, in seconds, that the server is queried.
To Next Page
Loading...
Need help?
General
