Alcatel-Lucent 7210 SAS-D - System Timing; Edit Mode

System Timing
Page 268 7210 SAS D, E, K OS Basic System Configuration Guide
System Timing
When synchronous Ethernet is enabled, the operator can select an Ethernet port as a candidate for
timing reference. The timing information recovered from this port is used to time the system.
Note: In the current release the derived time is distributed only through other Ethernet ports.
CLI Syntax for 7210 SAS-D:
*A:sas-d>config>system>sync-if-timing# info detail
----------------------------------------------
no ql-selection
ref-order ref1 ref2
ref1
shutdown
no source-port
no ql-override
exit
ref2
shutdown
no source-port
no ql-override
exit
ptp
shutdown
no ql-override
exit
no revert
----------------------------------------------
*A:sas-d>config>system>sync-if-timing#
ref1 ref2 ptp bits1 bits2
Edit Mode
To enter the mode to edit timing references, you must enter the begin keyword at the
config>system>sync-if-timing# prompt.
Use the following CLI syntax to enter the edit mode:
CLI Syntax: config>system>sync-if-timing
begin
The following error message displays when the you try to modify sync-if-timing parameters
without entering the keyword begin.
Note: Use the option commit to save or abort to discard the changes made in a session.