Alcatel-Lucent 7210 SAS-D - Configuring 1830 VWM

System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 275
Configuring 1830 VWM
The following output displays creation of vwm-shelf:
NOTE: The card 1 correspond to slot #1 and card 2 corresponds to slot #2 on the 1830 CWDM
device. The optical modules or line cards are inserted into these slots.
*A:NS1333C2676# configure system vwm-shelf 3 vwm-type ec-cw create
*A:NS1333C2676>configure>system>vwm-shelf$ info
----------------------------------------------
no shutdown
----------------------------------------------
*A:NS1333C2676>configure>system>vwm-shelf$ info detail
----------------------------------------------
card 1
shutdown
no card-type
exit
card 2
shutdown
no card-type
exit
no shutdown
*A:NS1333C2676>configure>system>vwm-shelf$
*A:7210 SAS>show system vwm-shelf 7
===========================================================================
Shelf Summary
===========================================================================
Shelf-ID USB/ Shelf Admin Oper Number of
OMC Type State State Equipped slots
---------------------------------------------------------------------------
7 OMC CWDM UP UP 2
===========================================================================
Slot Summary
===========================================================================
Slot-ID Provisioned Equipped Admin Oper
Type Type State State
---------------------------------------------------------------------------
1 Not Provisioned SFC1D DOWN DOWN
2 Not Provisioned SFC2A&B DOWN DOWN
A CWDM CWDM UP UP
===========================================================================
*A:7210SAS-E#
*A:7210SAS# show system vwm-shelf 7 detail
===========================================================================
Shelf Summary
===========================================================================