Alcatel-Lucent 7210 SAS-D - Page 328

PTP Commands
Page 328 7210 SAS D, E, K OS Basic System Configuration
Guide
PTP Commands
ptp
Syntax [no] ptp
Context config>system
Description This command enables the context to configure parameters for IEEE 1588-2008, Precision Time
Protocol.
This command is only available on the control assemblies that support 1588.
shutdown
Syntax [no] shutdown
Context config>system>ptp
Description This command disables or enables the PTP protocol. If PTP is disabled, the router will not transmit
any PTP packets, and will ignore all received PTP packets. If the user attempts to do a 'no shutdown'
on hardware that does not support PTP, an alarm will be raised to indicate limited capabilities.
When ptp is shutdown, the PTP slave port is not operational. It shall not be considered as a source for
system timing.
Default shutdown
clock
Syntax clock
Context config>system>ptp
Description Platforms Supported: 7210 SAS-K only.
Provides the context to configure the source of frequency reference for PTP.
freq-source