System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 333
This setting only applies to the range of values observed in the clockClass values transmitted out of
the node in Announce messages. The 7210 will support the reception of any valid value in Table 1/
G.8265.1
Default sdh
Parameters sdh — Specifies the values used on a G.781 Option 1 compliant network.
sonet — Specifies the values used on a G.781 Option 2 compliant network.
peer
Syntax peer ip-address [create]
Context config>system>ptp
This command configures a remote PTP peer. It provides the context to configure parameters for the
remote PTP peer.
Up to twenty remote PTP peers may be configured.
The no form of the command deletes the specified peer.
If the clock-type is ordinary slave or boundary, and PTP is no shutdown, the last peer cannot be
deleted. This prevents the user from having PTP enabled without any peer configured & enabled.
Peers cannot be created when the clock-type is ordinary master.
Default none
Parameters ip-address — The IP address of the remote peer.
Values ipv4-address a.b.c.d
create — keyword.
priority
Syntax priority local-priority
Context configure>system>ptp>peer>
This command configures the local priority used to choose between PTP masters in the best master
clock algorithm (BMCA). This setting is only relevant when the g.8265.1-2010 profile is selected.
The parameter is ignored when the ieee1588-2008 profile is selected. The value 1 is the highest
priority and 255 is the lowest priority.
The priority of a peer cannot be configured if the PTP profile is ieee1588-2008.
There is a limit of 20 configured PTP peers.
Default 128
Parameters local-priority — Specifies the value of the local priority.
To Next Page
Loading...
