Alcatel-Lucent 7210 SAS-D User Manual

System Resource-Profile Commands
Page 384 7210 SAS D, E, K OS Basic System Configuration
Guide
egress-sap-aggregate-meter
Syntax [no] egress-sap-aggregate-meter num-resources
Context configure>system>resource-profile>egress-internal-tcam
Description Platforms Supported: 7210 SAS-D
This command allows the user to allocate maximum resources for use by SAP egress aggregate
policer from the egress-internal-tcam resource pool. This command limits the total amount of chunks
allocated for use by SAP egress aggregate meter to the value specified by num-resources.
NOTE: The resources in the egress-internal-tcam resource pool are shared with other features (for
example: egress ACLs). To assign resources to this feature, resources may be to reallocated from
other features by disabling the policies association with a SAP, etc. (for example: to free resources
used by egress filter, the egress filter policy association command configured under a SAP needs to
be removed).
With the no form of the command, software does not allocate any resources for use by SAP egress
aggregate policer. If no resources are allocated for use, then the software fails all attempts to enable
the configuration of the command "sap-aggregate-meter" for a SAP.
Default no egress-sap-aggregate-meter
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
Values [0..2]
Default 0

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English