Alcatel-Lucent 7210 SAS-D User Manual

System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 393
The resources cannot be shared with IPv4 filter policies or IPv6 filter policies specifying 128-bit
addresses.
With the no form of the command, the software does not allocate any resources for use by filter
policies using ipv6 criteria with 64-bit IPv6 addresses. If no resources are allocated for use, then
software fails all attempts to associate a service entity (For example: SAP, IP interface, etc.) with a
ingress filter policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match crite-
ria.max — It is a special keyword. If user specifies max, then the software allocates one chunk when
the first SAP is associated with a ingress filter policy using this match criteria. It continues to allocate
resources to SAPs associated with a ingress filter policy using this criteria, as long as the total amount
of resources allocated does not exceed the resources allocated to ingress filter policies (configured
with the command config> system> resource-profile> ingress-internal-tcam> acl-sap-ingress
command) and chunks are available for use.
Values
mac-match-enable
Syntax [no] mac-match-enable
Context
configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
configure>system>resource-profile>ingress-internal-tcam> qos-sap-ingress-resource
Description This command allows the user to allocate maximum resources for use by ingress filter policies using
mac criteria. Or when used under the qos-sap-ingress-resource context, its used to allocates resources
for use by SAP ingress QoS policies using MAC criteria (any).
The resources cannot be shared with policies that use either IPv4 or IPv6 match criteria. For more
details about the resource allocation for ingress filter policy and fields available for use with ingress
filter policy please refer the 7210 SAS-D/E Router Configuration user guide. For more details about
the resource allocation for SAP ingress QoS policy please refer to 7210 SAS-DE QoS user guide.
With the no form of the command, the software does not allocate any resources for use by ingress
filter policies or SAP ingress QoS policies using mac criteria. If no resources are allocated for use,
then software fails all attempts to associate a service entity (For example: SAP, IP interface, etc.) with
a ingress filter policy or SAP ingress QoS policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
max — It is a special keyword. If user specifies max, then the software allocates one chunk when the
first SAP is associated with a ingress filter policy using this match criteria. It continues to allocate
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-D (per node) 0 3 max
7210 SAS-E
(per node)
011max

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English