Alcatel-Lucent 7210 SAS-D User Manual

System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 397
Values :
qos-sap-ingress-resource
Syntax qos-sap-ingress-resource
no qos-sap-ingress-resource
Context configure>system>resource-profile>ing-internal-tcam
Description This command allows the user to allocate maximum resources for use by SAP ingress QoS policies
using any of the supported match criteria. This command limits the total amount of chunks allocated
for use by SAP ingress QoS policies to the value specified by num-resources. In other words, the
cumulative sum of chunks allocated to different match criteria supported by SAP ingress QoS policies
cannot exceed the value configured with num-resources.
With the no form of the command, software does not allocate any resources for use by SAP ingress
QoS policies.
If no resources are allocated for use, then the software fails all attempts to associate a service entity
(For example: SAP, IP interface, and other service entities.) with a SAP ingress QoS policy using any
of the match criteria.)
NOTE: On 7210 SAS-K, when resources are allocated using this command only classification rules
with MAC criteria or IPv4 criteria. In other words, classification rules with IPv6 128-bit addresses
cannot use the resources until resources are explicitly allocated for IPv6 criteria using the command
configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource>mac-ipv4-
ipv6-128-match-enable.
Parameters num-resources — Specifies the amount of resources that can be allocated for use by SAP ingress QoS
policies.
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-D
(per node)
06max
7210 SAS-E
(per node)
03max

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English