System Commands
Page 416 7210 SAS D, E, K OS Basic System Configuration Guide
-------------------------------------------------------------------------------
System No limit 24,117,248 24,117,248 16,974,832
Icc 8,388,608 1,048,576 1,048,576 85,200
RTM/Policies No limit 5,242,912 5,242,912 3,944,104
OSPF No limit 3,145,728 3,145,728 2,617,384
MPLS/RSVP No limit 9,769,480 9,769,480 8,173,760
LDP No limit 0 0 0
IS-IS No limit 0 0 0
RIP No limit 0 0 0
VRRP No limit 1,048,576 1,048,576 96
Services No limit 2,097,152 2,097,152 1,589,824
IOM No limit 205,226,800 205,226,800 202,962,744
SIM No limit 1,048,576 1,048,576 392
IGMP No limit 0 0 0
MMPI No limit 0 0 0
MFIB No limit 0 0 0
PIP No limit 79,943,024 79,943,024 78,895,248
MBUF 67,108,864 5,837,328 5,837,328 4,834,280
-------------------------------------------------------------------------------
Current Total Size : 343,495,200 bytes
Total In Use : 324,492,768 bytes
Available Memory : 640,178,652 bytes
===============================================================================
A:ALA-1#
ntp
Syntax ntp [{peers | peer peer-address} | {servers | server server-address} |[all]] [detail]
Context show>system
Description This command displays NTP protocol configuration and state.
Output Show NTP Output — The following table describes NTP output fields.
Label Description
Enabled
yes — NTP is enabled.
no — NTP is disabled.
Admin Status
yes — Administrative state is enabled.
no — Administrative state is disabled.
NTP Server
Displays NTP server state of this node.
Stratum
Displays stratum level of this node.
Oper Status
yes — The operational state is enabled.
no — The operational state is disabled.
Auth Check
Displays the authentication requirement
To Next Page
Loading...
