Alcatel-Lucent 7210 SAS-D User Manual

Root Commands
7210 SAS D, E, K OS Basic System Configuration Guide Page 55
The output of this command is similar to the output of a show config command. This command, how-
ever, lists the configuration of the context where it is entered and all branches below that context
level.
By default, the command only enters the configuration parameters that vary from the default values.
The detail keyword causes all configuration parameters to be displayed.
For example,
*A:STU-1>config>service# info detail
----------------------------------------------
customer 1 create
description "Default customer"
no contact
no phone
exit
ies 1 customer 1 create
no description
interface "new" create
no description
address 21.0.0.2/8
no mac
arp-timeout 14400
icmp
redirects 100 10
unreachables 100 10
ttl-expired 100 10
exit
sap 1/1/18:0.* create
no description
ingress
no match-qinq-dot1p
no filter
exit
egress
no qinq-mark-top-only
no filter
exit
no shutdown
exit
no shutdown
exit
no shutdown
exit
vpls 100 customer 1 svc-sap-type dot1q create
no description
no disable-learning
no disable-aging
no discard-unknown
fdb-table-size 250
fdb-table-high-wmark 95
fdb-table-low-wmark 90
local-age 300
stp
shutdown
priority 32768
hello-time 2
forward-delay 15
max-age 20
hold-count 6
mode rstp

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English