Monitor CLI Commands
Page 118 7750 SR OS Basic System Configuration Guide
virtual-neighbor
Syntax virtual-neighbor nbr-rtr-id area area-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>ospf
monitor>router>ospf3
Description This command displays statistical OSPF virtual neighbor information at the configured interval until
the configured count is reached.
The first screen displays the current statistics related to the specified OSPF virtual neighbor router.
The subsequent statistical information listed for each interval is displayed as a delta to the previous
display.
When the keyword rate is specified, the "rate per second" for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters nbr-rtr-id — The IP address to uniquely identify a neighboring router in the autonomous system.
area area-id — The OSPF area ID, expressed in dotted decimal notation or as a 32-bit decimal
integer.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
group
Syntax group grp-ip-address [source ip-address] [interval interval] [repeat repeat] [absolute |
rate]
Context monitor>router>pim
Description This command monitors statistics for a PIM source group.
Parameters grp-ip-address — The IP address of an multicast group that identifies a set of recipients that are
interested in a particular data stream.
source ip-address — The source IP address to use in the ping requests in dotted decimal notation.
To Next Page
Loading...
Need help?
General
