Root Commands
7750 SR OS Basic System Configuration Guide Page 119
Default The IP address of the egress IP interface.
Values 0.0.0.0 — 255.255.255.255
interval interval — Configures the interval for each display in seconds.
Default 10 seconds
Values
10|20|30|40|50|60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
neighbor
Syntax neighbor neighbor [neighbor...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>router>rip
Description This command displays statistical RIP neighbor information at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the specified RIP neighbor(s). The
subsequent statistical information listed for each interval is displayed as a delta to the previous
display. When the keyword rate is specified, the "rate per second" for each statistic is displayed
instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters neighbor ip-address — The IP address to display information for entries received from the specified
RIP neighbor. Up to 5 IP addresses can be displayed.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
To Next Page
Loading...
Need help?
General
