LLDP Ethernet Port Commands
Page 406 7750 SR OS Basic System Configuration Guide
LLDP Ethernet Port Commands
Refer to the 7750 SR OS Interface Guide for command descriptions and CLI usage.
lldp
Syntax lldp
Context config>port>ethernet
Description This command enables the context to configure Link Layer Discovery Protocol (LLDP) parameters
on the specified port.
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Description This command configures destination MAC address parameters.
Parameters bridge-mac — Specifies destination bridge MAC type to use by LLDP.
Values nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay
(TPMR) .
nearest-customer — Specifies to use the nearest customer.
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Description This command specifies the administratively desired status of the local LLDP agent.
Parameters rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
information about the remote systems connected.
tx-rx — Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
disabled — Specifies that the LLDP agent will not transmit or receive LLDP frames on this port. If
there is remote systems information which is received on this port and stored in other tables,
before the port's admin status becomes disabled, then the information will naturally age out.
To Next Page
Loading...
Need help?
General
