Monitor CLI Commands
Page 80 7750 SR OS Basic System Configuration Guide
Ing. Matches: 0 Egr. Matches : 0
---------------------------------------------------------------------------
At time t = 6 sec (Mode: Rate)
---------------------------------------------------------------------------
Ing. Matches: 0 Egr. Matches : 0
---------------------------------------------------------------------------
At time t = 9 sec (Mode: Rate)
---------------------------------------------------------------------------
Ing. Matches: 0 Egr. Matches : 0
===========================================================================
A:ALA-1>monitor#
ipv6
Syntax ipv6 ipv6-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>filter
Description This command enables IPv6 filter monitoring. The statistical information for the specified IPv6 filter
entry displays at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified IPv6 filter. The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the "rate per second" for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters iv6p-filter-id — Displays detailed information for the specified IPv6 filter ID and its filter entries.
Values 1 — 65535
entry entry-id — Displays information on the specified IPv6 filter entry ID for the specified filter ID
only.
Values 1 — 65535
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without pro-
cessing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
To Next Page
Loading...
Need help?
General
