1 Publication 1734-UM002C-EN-P - July 2003
Chapter
1
Installing the 1734-ADN(X) Adapter
This chapter describes how to install and wire your adapter.
When properly installed, POINT I/O is grounded through the DIN rail
to chassis ground. We recommend using zinc plated, yellow
chromated steel DIN rail to assure proper grounding.
Other DIN rail materials (e.g. aluminum, plastic, etc.) can corrode or
oxidize and are poor conductors that may result in improper or
intermittent platform grounding.
If you choose not to use zinc plated, yellow chromated steel DIN rail
for your POINT I/O, we recommend occasional cleaning of the DIN
rail to prevent or lessen the effects of oxidation and corrosion.
For more information about: See page:
Installing the Adapter 1-2
Installing a Replacement DeviceNet
Adapter in an Existing System
1-4
Wiring the Adapter 1-5
Chapter Summary and What’s Next 1-6
To Next Page
Loading...
Need help?
General
