1 Publication 1734-UM002C-EN-P - July 2003
Chapter
5
Adding the 1734-ADN(X) to the DeviceNet
Scanner’s Scanlist
This chapter describes how to custom configure your adapter for use
with DeviceNet devices.
Your adapter works on two networks simultaneously and must be
configured for each separately, including separate RSNetWorx for
DeviceNet software files.
This chapter explains configuration of the adapter for use on the
primary DeviceNet network. For information on how to configure the
adapter for use on the Subnet see Chapter 4,
Configuring the
1734-ADN(X) Adapter’s SubNet.
Configuration Overview
You must use the RSNetWorx for DeviceNet software to configure
your adapter. You can configure the adapter while it is:
• online
• offline
This chapter shows configuration in the offline mode. Configuration
screens appear the same in both modes. The only difference is that if
you make changes offline, you must take the adapter online before
the configuration changes take effect.
For more information about: See page:
Configuration Overview 5-1
Adding the Adapter to Your Network 5-2
Setting the Adapter’s Parameters 5-3
Going Online 5-6
Chapter Summary and What’s Next 5-6
To Next Page
Loading...
Need help?
General
