Allied Telesis x530L Series User Manual

x530L Series Installation Guide for Virtual Chassis Stacking
183
4 Enter the SHOW RUNNING-CONFIG command to display the running configuration of
the master switch. You should use the display to confirm that you designated the
correct 5Gbps trunk ports for the master and member switches. The display should
contain INTERFACE PORT commands that identify the ports and are followed by
STACKPORT commands. In the following example, ports 15 and 16 on the master and
provisioned member switches are to be the stack trunk:
interface port1.0.15-1.0.16
stackport
.
interface port2.0.15-2.0.16
stackport
.
interface port3.0.15-3.0.16
stackport
.
interface port4.0.15-4.0.16
stackport
5 Go to “Configuring the x530L-18GHXm Member Switches” on page 192.
Table 27. Verifying the Master x530L-18GHXm Switch (Continued)
Step Description and Command

Allied Telesis x530L Series Specifications

General

Brand	Allied Telesis
Model	x530L Series
Category	Switch
Language	English