Name: Allied Telesis x530L Series
Brand: Allied Telesis
Rating: 4 (1 reviews)

To Next Page

To Previous Page

x530L Series Installation Guide for Virtual Chassis Stacking

Choosing a Site for the Switch

Observe these requirements when planning the installation of the switch.

 Before installing the switch in an equipment rack, check that the

rack is safely secured so that it will not tip over. Devices in a rack

should be installed starting at the bottom, with the heavier devices

near the bottom of the rack.

 Before installing the switch on a table, check that the table is level

and stable.

 The power outlets should be located near the switch and be easily

accessible.

 The site should allow for easy access to the ports on the front of

the switch, so that you can easily connect and disconnect cables,

and view the port LEDs.

 The site should allow for adequate air flow around the unit and

through the cooling vents on the front and rear panels. (The

ventilation direction is from front to back.)

 The site must not expose the switch to moisture or water.

 The site must be a dust-free environment.

 The site must have dedicated power circuits or power conditioners

to supply reliable electrical power to the network devices.

 Do not install the switch in a wiring or utility box because it might

overheat and fail from inadequate air flow.

Warning

Switches should not be stacked on a table or desktop. They could

present a physical safety hazard if you need to move or replace

switches.  E91

Questions and Answers:

Need help?

Do you have a question about the Allied Telesis x530L Series and is the answer not in the manual?

Allied Telesis x530L Series Specifications

General