Allied Telesis x530L Series - Verifying the Master X530 L-18 Ghxm Switch

x530L Series Installation Guide for Virtual Chassis Stacking
181
Verifying the
Master x530L-
18GHXm Switch
Perform the steps in Table 24 to confirm the configuration of the master
switch.
10 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
11 Type “Y” for yes.
12 Wait two minutes for the switch to initialize the management software.
13 Go to “Verifying the Master x530L-18GHXm Switch” on page 181.
Table 26. Configuring the Master x530L-18GHXm Switch for 5Gbps Stacking Ports – Part II
Step Description and Command
Table 27. Verifying the Master x530L-18GHXm Switch
Step Description and Command
1 Start a new local management session on the master switch.
2 Move to the Privileged Exec mode with the ENABLE command.
awplus> enable