Chapter 8: Building the Stack Trunk with 5Gbps Multi-Speed Ports
172
Verifying the
x530L-10GHXm
Master Switch
Perform the steps in Table 24 to confirm the configuration of the master
switch.
10 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
11 Type “Y” for yes.
12 Wait two minutes for the switch to initialize the management software.
13 Go to “Verifying the x530L-10GHXm Master Switch” on page 172.
Table 23. Configuring the Master x530L-10GHXm Switch for 5Gbps Stacking Ports – Part II
Step Description and Command
Table 24. Verifying the Master x530L-10GHXm Switch
Step Description and Command
1 Start a new local management session on the master switch.
2 Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
To Next Page
Loading...
