Copyright © 1996 General Motors Corp. 6–39
REBUILD OF SUBASSEMBLIES
(3) The clutch running clearance will be
within limits when the stack thickness measurement is
from 1.93–1.97 inch (49–50 mm).
(4) Use the parts measured when the trans-
mission is assembled (Paragraph 7–5a).
f. First Clutch
(1) Stack the first clutch plates and piston as
shown in Figure 6–67.
(2) Apply the specified load, and measure
Dimension X.
(3) From the table in Figure 6–67, select the
first clutch backplate. Use the parts measured, and the
selected backplate, when the transmission is assem-
bled (Paragraph 7–4a).
To Next Page
Loading...
Need help?
General
