Amazone Cayros Series - Turning with Double-Acting Automatic Cylinder in Conjunction with Hydraulic Beam Pivoting

Table of Contents
32
Cayros BAG0172.7
02.20
Connection to a single-acting control unit with oil return line to the tractor tank
The switching process for turning is the same as
with connection to a double-acting control unit,
but reverse turning in position R is not possible!
6.2 Turning with double-acting automatic cylinder in conjunction with
hydraulic beam pivoting
The beam pivoting cylinder is combined with the turning cylinder. In
turn, only one double-acting control unit or one single-acting control
unit with oil return line to the tractor tank is required for the turning
procedure. A second double-acting control unit is required to enable
adjustment of the cutting width.
Turning procedure:
When the control unit for turning is actuated, first the beam pivoting
cylinder is extended.
→ This causes the beam to pivot in.
The turning procedure takes place immediately and then the beam
pivoting cylinder is retracted
→ This causes the beam to pivot back to its original position.