BAG0172.7 02.20
2.2 Safety and accident prevention regulations
1. Operators shall wear close-fitting clothing. Solid footwear must
be worn.
2. Special care is to be ta
ken when handling any sharp and pointed
tools and components - Risk of injury!
3. Before initial operation, please familiarize yourself with all
equipment and operating elements as well as their function -
both on the tractor and on the plough!
It is too late to do this during working operation.
4. Use only stipulated parts for mounting the plough!
5. The mounting category (pin diameter, ball diameter) for three-
point linkage must be compatible for tractor and plough!
6. Special care must be taken when mounting or dismounting the
implement onto or from the tractor!
7. Prior to connecting and disconnecting implement to the three-
point suspension, place operating equipment in such a position
as to prevent unintentional lifting or lowering!
8. When actuating the external controls for three-point linkage, do
not step between tractor and plough!
9. When working between the tractor and the implement, ensure
that the vehicle is secured by the parking brake and/or wheel
chocks to prevent it from rolling away!
10. Before starting vehicle, check its road and operating safety!
11. Stickers concerning safety warnings must be kept clean and
legible! If damaged, they must be replaced.
12. Couple the implement according to the instructions. Handling,
steering and braking are all influenced by implement, and ballast
weight. Therefore ensure that the steering and brakes are not
impaired.
13. The respective road traffic regulations must be observed at all
times when using public roads.
14. When implement is in transport position, always ensure that
there is sufficient lateral locking of the tractor's three-point
linkage!
15. Packer arms must be swivelled in and locked before road
transport!
16. Observe the authorised axle loads, drawbar loads and total
weights!
17. Check surrounding vicinity (children!) before driving off!
18. When driving in curves, take account of the wide sweep and/or
centrifugal mass of the implement!
19. Do not leave the driver's platform while tractor is in motion!
20. Riding on the implement during work or road transport is not
permissible.
21. Before leaving the tractor, lower the implement to the ground,
switch off the engine, and remove the ignition key!
22. Before each transport journey, check the implement for any
damage, material fatigue, as well as for safe functioning of
relevant safety parts for road transport.
To Next Page
Loading...
