Amazone Cayros Series - Disc Coulter Adjustment for Vario

Table of Contents
42
Cayros BAG0172.7
02.20
7.8.2 Disc coulter adjustment for Vario
Only adjust the disc coulter in the
direction of travel with the largest
possible cutting width!
After loosening the bolt C and adjusting the
swing arm S, the depth of the disc coulter is
adjusted for the desired work depth so that the
hub does not touch the ground. When adjusting
swing arm S, make sure that the teeth interlock
smoothly and that the bolt C is securely
tightened.
The distance between the side of the disc and
the ploughing tackle should be between 1 and 4
cm, and at least protrude over fertiliser skimmer
coulter. This distance is adjusted by loosening
the locking bolt B and turning the bolt A.
Bolts A must be tightened again after adjusting
and locked with a hex. nut
Cau
tion when plough is in transport
position!
The lateral movement of the coulter must be
adjusted using the stop D (with transport
pendulum support wheel, the disc coulters must
be raised to the stop to prevent damage to the
wheel). With large amount of harvest residues,
the disc coulters must be set accordingly far to
the front on the shaped tube holder F. After
adjustments have been made, the bolts A must
be retightened and locked with hex. nuts.