Amazone Cayros Series - Disc Coulter Adjustment for Automatic Stone Release

Adjusting the plough
Cayros
BAG0172.7 02.20
43
7.8.3 Disc coulter adjustment for automatic stone release
After loosening bolt S1 and adjusting the rocker
bar A, the depth of the disc coulter is adjusted
for the desired work depth so that the hub does
not touch the ground. When adjusting rocker
bar A, make sure that the cogs engage
smoothly and that bolt S1 is se
curely tightened.
The distance between the side of the disc and
the ploughing tackle should be between 1 and
4 cm, and at least protrude over fertiliser
skimmer coulter. This distance is achieved by
rotating the coulter shaft C
. Rotation is enabled
by loosening the bolt S2.
Lateral swing of coulter is to be set using stop
(B).