BAG0172.7 02.20
7.4 Working depth adjustment
Increase:
Set the control hydraulics to greater depth, shorten top
link, raise the support wheel(s).
Decrease:
Set the control hydraulics to a smaller depth, lengthen
top link, lower the support wheel(s).
Depth adjustment using the control hydraulics, see operating
manual from the tractor manufacturer.
Depth adjustment with double support wheel
Pull out the ball knob K from each support wheel stalk St and turn by
90°. Shift the support wheel R to desired depth and allow the ball
knob to latch back into place.
Depth adjustment with pendulum transport support wheel /
pendulum support wheel
The depth is adjusted manually, without tools.
→ Larger working depths: Turn in the catch E
→ Smaller working depth: Turn out the catch E
The catch E engages automatically by means of the spring-
loaded pressure piece K.
There is no need for tools to fasten the catch!
To Next Page
Loading...
