BAG0172.7 02.20
7.6 Pulling point setting
The plough should generally be set so that there
is no lateral pull on the tractor. Put lower lift arms
in correct positon to avoid lateral pull.
For normal usage the plough is set so that
mounting body (A) runs centrally to the tractor
tracks. The adjustments are made using the pull
point spindle S on the beam pivoting cylinder.
For ploughs with beam pivoting (M, XM, XMS,
XS, XSPro), the beam pivoting cylinder must
be fully retracted!
Tractor pulls towards the ploughed soil
Adjust the lower link towards the ploughed soil
→ Screw the pull point spindle S together
Tractor pulls towards the unploughed soil:
Adjust the lower link towards the unploughed soil
→ Screw the pull point spindle S apart.
Standard:
To Next Page
Loading...
