Cayros BAG0172.7
10.1 Cleaning
• The implement must not be cleaned with a steam jet cleaner
within the first 3 months! After this time, only clean at a nozzle
distance of at least 50 cm at 100 bar and 50°C!
• When the cleaning and care instructions are not observed, any
resulting paint damage will not be covered by the warranty!
• Monitor brake, air and hydraulic hose lines particularly carefully
• Never treat brake, air or hydraulic hose lines with benzin,
benzene, petroleum or mineral oils.
• Lubricate the trailed sprayer after cleaning, particularly after
cleaning with a pressure washer / steam jet, or fat-soluble
mediums.
•
Observe the statutory requirements for the handling and removal
of cleaning agents.
Cleaning with a pressure washer / steam jet
• Always observe the following points when using a pressure
washer / steam jet for cleaning:
ο Do not clean any electrical components.
ο Do not clean any chromed components.
ο Never aim the cleaning jet of the cleaning nozzle of the
high pressure cleaner/steam jet directly at lubrication
points, bearings, rating plates, warning signs, and stickers.
ο Always maintain a minimum jet distance of 300 mm
between the pressure washer or steam jet cleaning nozzle
and the machine.
ο The set pressure of the high-pressure cleaner / steam jet
must not exceed 80 bar.
ο Permissible water temperature max. 50°C.
ο Do not clean the implement with warm water at ambient
temperatures below 10°C.
ο The nozzle spraying angle must be at least 25°.
ο Do not use a spraying jet booster.
ο Comply with safety regulations when working with pressure
washers.
To Next Page
Loading...
