Cleaning, maintenance and repair
BAG0172.7 02.20
• Observe legal requirements when disposing of lubricants, e.g.
oils and grease. Also affected by these legal requirements are
parts that come into contact with these lubricants.
• Do not exceed a greasing pressure of 400 bar when greasing
with high pressure grease guns.
• The following are prohibited
ο drilling the running gear.
ο drilling through pre-existing holes on the transport frame.
ο welding on load-bearing components.
• Protective measures are necessary, such as covering lines or
removing lines in particularly critical locations
ο during welding, drilling and grinding work.
ο when working with cut-off wheels near plastic wires and
electric wires.
• Clean the implement thoroughly with water before carrying out
repair work.
• Always disconnect the implement cable as well as the power
supply from the on-board computer when performing any care
and maintenance work. This applies particularly to welding work
on the implement.
To Next Page
Loading...
