BAG0172.7 02.20
8.1 Rear transport pendulum support wheel
Move the transport swing support wheel into
transport position:
• Detach the hydraulic damper A from the
support wheel stalk (remove split-
up and position it between the lugs using
the linch pin.
• Remove locking pin B
pin and pulling the locking pin out.
• Raise catch C and fasten it in hole D using
the linch pin so that the support wheel stalk
can be lifted out of the lower stop and thus
be pivoted by 90° about the pivot point bolt
E.
The locking pin B is then re-installed.
To Next Page
Loading...
