Cayros BAG0172.7
7.9 Fertiliser skimmer
The fertiliser skimmers must be set so that the working depth is
approximately 1/3 of the plough body working depth. For large crop
residues, it can also be set somewhat deeper. Should the fertiliser
skimmers be obstructed by oversized crop remains, they can easily
be removed by loosening 3 screws.
For adjustable fertiliser skimmers, the lateral dimensions are set so
that the particular share tip of the fertiliser skimmers is at a distance of
ca. 15 -
20 mm from the share tip of the plough body. The share tip of
the fertiliser skimmer should always be used in firm ground to prevent
"sliding". If stubble treatment was carried out before ploughing, the
fertiliser skimmer has to be set somewhat deeper in order to ensure
that mulching is carried out effectively and without blockages.
This adjustment also applies to skim coulters or special feed devices.
Use on stony soils is not advised (no stone release).
Driving in curves forbidden!
It is forbidden to drive in curves during operation due to overstraining
of the implement!
To Next Page
Loading...
