Amazone Cayros Series - Front Furrow Width - Rough Adjustment of the Plough on the Tractor

Table of Contents
36
Cayros BAG0172.7
02.20
7.3 Front furrow width - Rough adjustment of the plough on the tractor
Depending on the different clear spans of the
tractor wheels A and the set cutting width S, the
plough is first roughly adjusted carried out using
the slide block guide by means of the width
adjustment spindle V.
This gives the adjustment dimensions
X
=
A/2 - S
For ploughs with beam pivoting (M,
XM, XMS, XS, XSPro), the beam
pivoting cylinder for the track
adjustment must be fully retracted
for this setting.
For practical operation (pitch
adjustment), the measurement X
must be reduced depending on the
working depth.
Perform the rough adjustment of the front furrow
width at a standstill in the farmyard.
1. Couple the implement and raise the jack.
2. Relieve the slide block guide using the
tractor hydraulic system.
3. Adjust the front furrow mechanically using
the spindle or hydraulically using the tractor
control unit.
→ If necessary, perform the adjustments in
several steps. Relieve the slide block guide
after each adjustment.