BAG0172.7 02.20
7.8 Disc coulter adjustment
7.8.1 Disc coulter adjustment for standard
After loosening the bolt S and adjusting the
swing arm A, the depth of the disc coulter is
adjusted for the desired work depth so that the
hub does not touch the ground. When adjusting
swing arm (A), make sure that the toothed
serrations slots
together smoothly and that screw
(S) is securely tightened.
The distance between the side of the disc and
the ploughing tackle should be between 1 and 4
cm, and at least protrude over fertiliser skimmer
coulter. This distance is achieved by rotating the
coulter shaft C. Rotation is enabled by loosening
the clamping bar (D
) . Of the two screws, use the
one which is furthest away from the coulter shaft
C to loosen and re-tighten the clamping bar
(better clamping effect).
Lateral swing of coulter is to be set using stop
(B). When there are large quantities of harvest
remains, set the disc coulters on holder (H)
forward accordingly
For shear pin disc coulter plough types, the
lateral distance is adjusted by means of a
torsion-locked slot in the coulter shaft holder.
To Next Page
Loading...
