Amazone Cayros Series - Checking the Support Wheel

Table of Contents
60
Cayros BAG0172.7
02.20
10.6 Checking the support wheel
• Regularly check
ο that wheel nuts are firmly seated.
ο tyre inflation pressure.
Support wheel
diameter Ø
Required tyre inflation pressure
Required tightening torque for
wheel nuts / bolts
500
-
-
550
5.0 bar
-
580
3.6 bar
150 Nm
Single shaft
600
5.0 bar
260 Nm
Double shaft
680
3.9 bar
260 Nm
Double shaft
690
4.0 bar
260 Nm
Double shaft
10.6.1 Check bearing clearance on wheel hubs
1. To check the bearing clearance on the
wheel hubs, lift the axle until the wheels are
free.
2. Release the brake.
3. Place a lever between the tyre and the
ground and check the bearing clearance.
If there is noticeable bearing clearance:
Bearing clearance adjustment →
Workshop work
1. Remove the dust cup or hub cap.
2. Remove the cotter pin from the axle nut.
3. Tighten the wheel nut by simultaneously
turning the wheel until the run of the wheel
hub is lightly braked.
4. Turn the axle nut back to the next possible
cotter pin hole. If there is congruence, to the
next hole (max. 30°).
5. Insert the cotter pin and bend it up slightly.
6. Replenish the dust cap with some long-
term
grease and pound or screw it into the wheel
hub.